Dump trucks, tractor units, semi-trailers, low beds and truck-mounted cranes — configured in Liangshan for the duty cycle you actually run: open-pit mining, desert long-haul, port transfer and urban construction.
1
2
3
HOWO-371
Not a truck shop that also sells trailers. Five product lines, one export desk, one bill of lading. Open a line to see every variant we build — or filter the fleet below by line and by sourcing type.
Body not on the list? Plate thickness, deck length, axle spacing and paint are changed on order — send the drawing or the job, we quote the build.
SEND A BUILD REQUEST →Most exporters show you a wall of trucks. We start from the ground you drive on. Pick the working condition — we bring the configuration, the axle count, the cooling package and the tyre spec that survives it.
Reinforced 16 mm body, 8 mm floor plate, 20-ply mining tyres, enlarged radiator + oil-bath air filter, rear-axle ratio 5.73.
TM-D375 8×4 DUMP →Dual-stage fuel filtration, 600 L + 400 L tanks, sand cyclone pre-filter, cabin A/C upgrade, 90 km/h economy rear-axle ratio.
TM-T460 TRACTOR + TM-S40 →Marine-grade anti-corrosion package, sealed harness, 3-axle low bed or container skeleton, 50 mm kingpin, WABCO valve set.
TM-X75 HEAVY HAUL →12 t knuckle-boom or straight-boom crane, 8 m³ mixer drum, short wheelbase chassis, rear stabilisers, work lamps.
TM-C12 CRANE / TM-M12 MIXER →60 sub-categories across five lines — 8 products in every category. Pick a category, then the configuration: axle count, body, tyre, cooling and paint are agreed line by line before the proforma.
Tick COMPARE on any unit above and it lands here. Rows marked ▲ differ between the selected models.
| PARAMETER | TM-D375DUMP 8×4 | TM-T460TRACTOR 6×4 | TM-C12CRANE 12 T |
|---|---|---|---|
| Engine | WP12.430 | WP13.460 | WP10.350 |
| Rated power | 375 HP | 460 HP | 350 HP |
| Drive | 8×4 | 6×4 | 6×4 |
| Emission | Euro II / III | Euro II / III | Euro II / III |
| GVW / GCW | 31 T | 90 T | 25 T |
| Payload | 40 T | — | 12 T |
| Body / deck | 18 m³ dumper | fifth wheel | flatbed + crane |
| Axles | 4 | 3 | 3 |
| Tyres | 12.00R20 | 12.00R20 | 12.00R20 |
| Fuel tank | 400 L | 600 + 400 L | 300 L |
| Cabin | HW76 sleeper | HW76 sleeper | HW76 day |
| Lead time | 15 – 25 d | 20 – 30 d | 25 – 35 d |
| Warranty | 12 mo / 100,000 km | 12 mo / 100,000 km | 12 mo / 100,000 km |
| FOB Qingdao | USD 41,800 | USD 45,600 | USD 52,300 |
Prices are indicative and move with configuration, quantity and shipping method. Final numbers are issued as a signed proforma within 24 h of enquiry.
A truck that stops for a 40-dollar seal is not a cheap truck. Every unit can leave with a parts package sized to your fleet — genuine, OEM-equivalent or high-wear, your call.
Pre-packed for 12 months / 100,000 km of duty. Ships inside the container, no extra freight.
Door-to-port in China, port-to-site on your side. You always know which stage the unit is in and which document is next.
D1 – D3
Configuration sheet signed, proforma issued, PI confirmed.
D4 – D20
Body, crane, tank or paint completed; photos sent every 5 days.
D21 – D23
Load test, brake test, leak test; SGS / BV on request.
D24 – D27
To Qingdao / Lianyungang; RO-RO, flat rack or bulk booking.
D28 – D32
B/L, CIQ, CO / FTA, packing list, insurance, ECTN where required.
+ 18 – 38 d
Lagos, Dar es Salaam, Mombasa, Jebel Ali, Manzanillo, Veracruz.
Duty-cycle data, spec decisions and shipping arithmetic — written by the export desk after the units came back with hour meters on them.
Tractor, trailer and crane matched as one package — no fifth-wheel mismatch, no wiring conflicts, no split liability.
Liangshan body and upfit line: plate thickness, rib spacing and cylinder mounting are changed on order, not quoted from a catalogue.
1 unit or 30 — the wear-parts kit is sized to your annual running hours and shipped with the order.
CO / FTA, ECTN, SONCAP, PVoC and consular documents are drafted before the vessel sails, and sent to you to check first. If a document is rejected at destination because of our error, the corrected set is couriered at our cost.
All four are written into the proforma, not left to goodwill: inspection standard, spare-parts list, document set, and the week the vessel sails.
Four fields. We answer with a configuration sheet and an indicative FOB number within 24 hours.
Every enquiry goes to the partner who handles it. All e-mail on this site lands in one export-desk mailbox that the four of them read — or reach them directly on WhatsApp or WeChat. Write to enquiries@shandongheavymach.com.
Final say on price, contract terms, fleet programmes and large orders.
Quotations, configurations, drawings and proforma invoices. Start here for a price.
Contracts, payment terms, LC and commercial conditions. Agency and long-term supply.
Export documents, inspection, loading and port logistics. Spare parts and wear kits.